Future-automation PD Manual do Utilizador descarregar pdf (Página 16)

Trouble Shooting:

Page 15 of 18 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565

PD1 & 2 - Projector Drop Mechanism

PD1 & 2 Projector Drop Mechanism - Trouble shooting guide

Having problems? - Check the following:

1. Are all the connections correct?

2. Is the mechanism being operated correctly?

If the mechanism does not operate correctly, check the items listed in the table below.

Should the problem persist, there may be a malfunction. If this is the case, disconnect the

mains power immediately and contact your installer

SymptomCause RemedyPage

Emergency stop removed Replace emergency stop 14

Remote control or batteries

faulty

Replace batteries or remote 15

Motor end stops incorrectly

set

Adjust end stop 10

Incorrect pin configuration

Terminate 8-pin RJ45 to 568/b pin

configuration

Faulty wiring Replace connector or cable 13

Faulty control box Test contact closure on control box 13

Incorrect settings Refer to instructions 14

Incorrect pin configuration

Terminate 6-pin RJ11 to

configuration supplied

ASC11 protocol error Amend Protocol 14

Lift not level Cables over lapping/damaged re-seat cables 11

Lift not working

Contact closure not working

RS232 not working

1 2 ... 11 12 13 14 15 16 17 18 19 20

Sem comentários

Future-automation PD Manual do Utilizador Página 16